Teak Magic Part 1 is specially engineered to safely clean and restore teak decks and wood furniture to their natural color and brightness without damaging the wood surface. Its gel consistency makes it ideal for controlled, even application.

For deep or heavy-duty cleaning of all teak surfaces, including large teak decks and teak furniture. Ideal for use in areas with sensitive surroundings (including finished metals). If product comes in contact with soft metals (aluminum, brass, etc), rinse off with water immediately.

Make sure to wear proper safety gear, including nitrile gloves. For best results, apply to a damp surface.

1. 1 In a clean bucket, mix one part Teak Magic Part 1 with four parts fresh water (1:4). Spread product completely and evenly onto the surface using a foam brush, deck brush, or polypropylene scrub pad.
2. 2 Allow Part 1 to dwell on the surface for 3–5 minutes.
3. 3 Using a medium polypropylene scrub pad, scrub the teak both with and against the wood grain with medium pressure to loosen dirt and contaminant particles.
4. 4 Thoroughly rinse dirt and product off the teak with fresh water, including areas like cleats and scuppers where dirty water/product may flow and puddle. Then apply Teak Magic Part 2 (Brightener).

Teak Magic Part 2 brightens and restores the teak’s natural color after cleaning. Applied after Part 1, it does the work without scrubbing.

For deep or heavy-duty brightening of all teak surfaces. Ideal for use in areas with sensitive surroundings. If product comes in contact with soft metals (aluminum, brass, etc), rinse off with water immediately.

Make sure to wear proper safety gear, including nitrile gloves.

1. 1 After thoroughly rinsing off Part 1, remove excess puddles of water. Surface should be damp. In a clean bucket, mix one part Teak Magic Part 2 with four parts fresh water (1:4).
2. 2 Apply Part 2 to the damp surface. Spread product completely and evenly using a foam brush, soft bristle deck brush, or medium polypropylene scrub pad. There is no need to scrub — let the product do the work.
3. 3 Allow Part 2 to dwell on the surface for 3–5 minutes.
4. 4 After teak has brightened, rinse the surface thoroughly with fresh water, including cleats and scuppers. Remove excess water and allow teak to dry completely before applying DiTEC Triton 2.0 for protection.